blow through turbo kit.

consists of:

-vg20 T3 - good shaft wise but leaks oil from the seal between the housings. New seal or just replace it.

-a14 manifold and J-pipe, well made goes under the engine mounts and bolts to the block for support, so it shouldnt ever crack.

-Dump pipe to suit

-prepped 32/36 weber, ran beautifully on an a14, started easy, idled great.

-custom alloy carby hat, includes pittings for fuel reg, boost guage etc, includes blowoff valve

-piping from turbo to carby hat, with silicon hoses

-turbosmart boost tee

-sump with oil return to suit turbo

- custom water pipe for the block to avoid the turbo

-T-piece to provide oil for turbo, oil lines

-T-piece to provide water for turbo

-custom accelerator cable

-speco boost guage

-malpassi rising rate regulator

Whats not included, but is needed:

-rest of the exhaust

-air filter (any pod filter will do)

-fuel return line (for fuel reg)

-fuel pump

This is a well made setup and is very streetable. Power output is unknown, as it was running on a high comp motor and broke a piston.

$800 firm for the lot+postage ($100max within Aus) - its heavy!