Browsing this Thread:
1 Anonymous Users
|
|
Re: Hmmm new boat anchor, or a12 stroker |
|
Just can't stay away  
Joined:
2001/1/20 8:04
Group:
Registered Users
|
Isn't the relationship with the crank and rods also important when stroking a motor. I thought I read a couple of different articles that talked about longer stroke cranks but shorter
rods. Also the compression height of the piston is a factor as well isn't it. I mean couldn't 2 similar motors have the same stroke measurement but one have a longer rod and shorter piston
height. I was thinking of this when I went through a listing of bigger pistons for the A15 just looking for something with the same stroke but bigger bore to increase my capacity. This
could end up with the wrong combination depending on the piston and pin height couldn't it. In that case are E15 pistons a straight swap in. I was thinking of using the turbo E15 pistons
if I turbo the A15.
Gavin
Posted on: 2001/4/18 7:15
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
