haha my bad dude. should have read it properly.
What shocks have you used in your coilover setup?

Im not an engineerer or anything but i think you will be fine with a shorter hub to compensate the 8mm. If you for some reason decided to make a longer hub then i would be worried of the stress levels pulling on bearing and stub axle.
Because it will be that little be shorter you would think the forces would be acting in a more "central" (for lack of a better word) manner of the bearing/stub axle rather than creating a large torque around the bearing/axle if it was further out with a longer hub.
Like holding a ruler at the very end and waving it around then holding it further to the middle and waving it around... les wave


Im sure you will be fine. Prob pay to check with an engineer rather than us though as im sure he would be much more help.
Any pics of the coilover setup nowadays?