Browsing this Thread:
1 Anonymous Users
|
|
Re: tcd ? |
|
Just can't stay away  
Joined:
2007/11/3 7:57
From Sydney (Carlingford)
Group:
Registered Users
|
Yes, when the timing mark is on "0" that is Top Dead Centre (TDC) and the valves are fully closed on the cylinder that is firing (which will be either No: 1 or No: 4 cylinder).
When you do the distributor timing, it is set at about 10 degrees Before Top Dead Centre "BTDC". This allows time for the burn to expand and be compressed before sending the piston back down the bore.
If you are setting the tappet adjustment you should be able to put the timing mark at TDC and adjust four of the tappets then rotate the crank once back to TDC and adjust the other four.
Hope tha helps.
Posted on: 2008/1/5 7:48
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
