I did some more work today and finished the side panels and kick ups behind the wheels.




After this pic was taken I continued to work on the car. I realized that there is a need for providing an exit for the radiator and exhaust heat. Remember, by closing off the bottom of the car, I've also closed off the normal escape point of the underhood cooling air [between the frame rails along both sides of the engine]. This cooling air from the radiator must be able to flow through or it will back up and the engine will overheat], not to mention the adding unwanted aero drag. So I cut some large slots into the rear of the belly pan to [hopefully] keep things in balance. I'm sure the floor temp of the car will be raised as well. Between that, and having the windows up tight [for lower aero drag] it will be a good thing I am bringing a cooler with cold towels in it to wear as my "air conditioning".