Yes "CAMBER PINS" these are used to adjust wheel alignment setting, usually found connecting lwr control arms to crossmember, this bolt has 2 off circle plates at either end and usally sit in a boxed "C" section found on crossmember and when moved, moves control arm in and out
To save questions, these are not going to give you 3 degree's to go tar mac racing , when they were in my ute i got about a degree of adjustment out of them, these would be a solution for someone who has got positive camber and may have a problem wearing out out side edges of tyre's, I used to do Wheel alignments for a living and have set up many Rally, road and drag cars, i am more then happy to answer questions..If you have not seen these be 4 please wait till pics come up....Just havving a shot at ya champ, i take you already know what they are but have not seen these on a 1200, these were already in the car when i got it, I not shore this is factory or not (doesn't look like it buy the welds, there not rough but.) but does have propper pins. These look just like a XD/XF set up.