Browsing this Thread:
1 Anonymous Users
|
|
Re: A Series Expert? |
|
Home away from home  
Joined:
2004/1/1 7:57
From Brisbane
Group:
Registered Users
|
I'm just going through exactly the same scenario, spun a big end - replaced all big end bearings - went for a drive around the block and spun the same bearing (the night before a rally)
I spoke to the guy who does my bottom end machining and he says that 99% of the times you spin a big end bearing you distort the big end on the conrod and in most cases you bend the crankshaft.
So guess what I'm doing tomorrow.....pulling the motor out and checking everything, hopefully I haven't bent the crank.
Posted on: 2008/11/9 6:58
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
