Browsing this Thread:
1 Anonymous Users
|
|
Re: What driveshaft behind sr20 into 1200 |
|
Home away from home  
Joined:
2004/8/30 11:04
From Christchurch
Group:
Registered Users
|
I know what your saying but I have neither so I figure if I have to buy both ends one of them might as well have the rest of the driveshaft attached.
I'm either going to buy a commondore driveshaft (to match my borgwarner diff) and get an sr20 spline or if there is a nissan/datsun one piece driveshaft that goes in the sr box i'll get that and get a borgwarner yoke. Then just get the driveshaft shortened and the new end put on.
Probably the first as that will probably be the easier route, commodore bits are easy to find.
I was more interested to know if someone had found a nissan/datsun 1 piece driveshaft that went straight in the end of the sr box.
Posted on: 2008/12/13 8:39
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
