Thanks mate. Motor and box in after a stuff around trying to use a CA20 bluebird box with CA18 bell housing we decided to dig out the stumpy swap the bell housing and use it. Had problems with clearance yes even with a bluebird tunnel in it which mainly stems from the engine height. It could be a lot lower but the bonnet has plenty of clearance when back on and shut so I'm all good may finish off me other CA X member later on it has been scalloped to allow for lower engine. Bluebird gearbox X member bolts up and will fit with a bit of tweaking or may just make a fresh one. Getting there slowly mainly just want to get it all hooked up and running as well as all brakes setup and electrics so i can then pull it down fix my list of stuff/mods and paint it.

Attach file:

---

  Wagon 001.jpg (124.74 KB)


  Wagon 002.jpg (108.66 KB)


  Wagon 003.jpg (96.73 KB)