Browsing this Thread:
1 Anonymous Users
|
|
Re: cam grinds? |
|
|
Just popping in
Joined:
2009/1/11 7:43
From Adelaide S.A
Group:
Registered Users
|
I use wade cams, they can regrind your old cam to whatever specs you choose. You want lobe seperation angle of 114+ degrees and duration as large as the power range you are chasing, lift as much as your valve train can handle without coil bind or piston to valve clearance. Dont be afraid to go as large as 230/230 @ 50 if your chasing good power @ 3000rpm+ and have good intake/exhaust. The bigger the cam you run the higher the compression you can get away with due to cyl bleed off. Most people recomend baby 210 degree cams for use with boost but you wont make much power with them, cant even hear there in there. Hope that helps ya bud.
Posted on: 2009/5/24 5:10
|
|
_________________
Affordable Performance and Mechanical Repairs
0421 221 821
Adelaide
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
