Browsing this Thread:
1 Anonymous Users
|
|
A12 Extractors |
|
Quite a regular  
Joined:
2009/6/15 3:05
Group:
Registered Users
|
hey all,
got some 4-2-1 extractors of a member just yesterday and i got the steel brush and cleaned them up and sprayed them with some heat proof pressure pack, "cast iron" grey.. now the car was dropped into the exhaust shop today to get them hooked up. but when i was looking at the engine yesterday i noticed the inlet manifold seems to be "connected" to the exhaust manifold.. i was a little confused at first but i wasnt sure if it is just there to support it or what? now my question is that if the extractors are put on then will that effect the inlet manifold in any way??
also will it be very loud with 4-2-1 single 2 inch pipe to single strait through muffler??? stock motor
Posted on: 2009/6/26 0:19
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
