Browsing this Thread:
1 Anonymous Users
|
|
Re: 12a 6 port rotary motor & 6 speed manual gearbox. |
|
Quite a regular  
Joined:
2008/10/23 9:00
Group:
Registered Users
|
hey mate, no there are no engine or gearbox mounts! i hadnt made any yet, the motor was just sitting under the car on a stand that i made up! wouldnt be hard to make mounts! you will have to cut the center out of the original crossmember to allow the motor to sit low enough, i have a template crossmember made out of cardboard (to exact measurments) that will do the job, i have showed a engineer this crossmember and he said it was fine! trans tunnel will have to be cut out and enlarged! thanks, justin.
Posted on: 2009/8/31 8:47
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
