im undecided after much study into what I could do improve the flow.
Well so far raising the ports with bias to increase the flow and speed.
This time leaving the inlet plugs and remove exhaust side plugs.
Exhaust side plug area will be filled.
This will keep the swirl tighter and away from the bore walls.
The other day went to check out a kawasaki zx14 head and all the water
galleries and bore line up. Head bolts where close apart from the 2 back
and the 2 front ones but the block has space for them. Maybe in the future.
http://datsun1200.com/modules/newbb/v ... id=363812#forumpost363812KAWASAKI 16V HEAD TRIAL