Browsing this Thread:
1 Anonymous Users
|
|
Re: CAD Model of 1200 saloon |
|
|
Just popping in
Joined:
2009/12/10 5:37
Group:
Registered Users
|
Thanks again for the blueprints.
The aspect ratios needed to be adjusted just a little before all of the written dimensions would actually match correctly in Solidworks. At this point, I can draw construction lines at points on the car, measure the distances between and they'll match the drawing! YES
Well... here goes my first vehicle model attempt! Hopefully the +/- error wont be too bad - if its under 5cm, I'll be happy. This is only to experiment with possible engine/axle swaps, and to play with the visual appearance, etc.
Attach file:
 bluprinted_body.JPG (38.31 KB)
Posted on: 2010/1/17 4:16
|
|
_________________
Looking for blueprints of 1200 interior/chassis bits!!!
Scottsdale, Arizona, USA
Employed: Software Engineer
Interests: shifter karting, design of Formula race cars, manufacturing, design of embedded electronics for raci...
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
