Hi peoples,

I've been reading your forum for about a week now, hence the registration, I own a 1971 B110 1200 sedan with the A12 motor in it and 4 speed. It's going to be slowly upgraded but only with datsun bits, and is still on it's original plates.

I recently bought a 63a #3 dogleg 5 speed out of a stanza sss 1600, with the goal of (this coming thursday night) installing it in the 1200 sedan.

What I'm asking for is a quick check list of parts that I'll need to have to achieve the change over.

I know that (or think I know)

- the 63a gearbox support strut will be 20mm out so make some adapter plates

- the gearbox output shaft is bigger so I have to swap the one that came with the box onto my existing tailshaft (I just physically checked before posting this)

- the speedo cable will need to be replaced with a longer one

- the clutch plate is possibly going to have to be replaced with one from a stanza, but that's where I have an issue

the stanza clutch plate is 200mm with 25.5 hole with 24 teeth according to the exceedy parts cat - and the B110 is 180mm with 20.5 hole with 18 teeth.

if I replace the plate I'ld therefore have to replace the pressure plate as well etc (get a clutch kit which would include the thrust bearing), but will this larger clutch kit fit up to my flywheel? or do I need to replace that too?

Any and all advice will be greatfully accepted :)