Browsing this Thread:
1 Anonymous Users
|
|
Re: pushrods.. |
|
Moderator  
Joined:
2001/5/3 7:04
From 48 North
Group:
Registered Users
Contentmaster
Usermaster
|
Length
It is important to use the correct length for proper Rocker geometry. If the cylinder head is skimmed beyond the service limit, or the block deck is cut down, custom push rods are needed.
• 141.5 mm: A10 engine
• 152 mm: short-deck engines (A12, A12A, and 1980 A13)
•~167 mm: tall-deck engines (A14, A15, and 1974 A13)
Custom pushrods made to length from VW pushrods and using the A-series cup. They sit the turned down cup shaft on a ledge in the alloy. Custom made to your length and cheap.
Posted on: 2010/5/21 19:02
Edited by ddgonzal on 2010/5/21 23:04:39
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
