Have finished both the engine and gearbox crossmembers, Both are fully welded etc.

Gearbox Crossmember - Used the auto datto crossmember with the ca18's center part. Just whacked some 5mm plate between the two and welded.





Engine Crossmember - Used 5mm plate for the engine mounts, also notched out the top of the middle so the sump has clearance to be a bit lower.





Just waiting for the paint to dry on the engine crossmember and i'll chuck it in tomorrow morning. Then start on the wiring I guess as I still need to get a radiator and few bits for the rest of cutting and fabrication.