Right Im not after the ultimate performance for one of my K projects
so Im aiming for better than standard in looks and performance :)
The inlet is going to go up into 90 degree bends and a small plenum for
a single 2 inch SU carburettor or 1.75 stromberg sitting on a 45 degree
angle with a velocity stack all shined up. Either on the same side or
curving over to the other side to increase torque down low on the asthmatic
A10 with its 59mm stroke.
Here is so far what Im thinking but in stainless steel tubing meeting
bent at the end to meet the rest of the exhaust.
The first 2 pics are the inspiration...

Attach file:

---

  rodex2.jpg (18.59 KB)


  rodex.jpg (189.27 KB)


  b10xtra2.JPG (191.68 KB)