The old girl proberly had a hard time for its age.haha.

HOW TO FIX IT,(or this may enhance the problem,then u need a "bigger catch" can)


*Lift her top (bonnet)
*scratch the head (is she worth it)
*pull it out (engine)
*strip her down (engine)
*do the in and out motion (hone)
*fit some tickers (rings)
*get a good head job (valve service)
*don't forget the rubbers (valve seals)
*slap her bits gently back together (assemble)
*put it back in (engine in car)
*turn her on (start it up)
*gently warm her up (get temp)
*she will be a bit tight (fresh rebuild)
*so be gentle at first (run in)
*after a few good night (gathering kms)
*drive it hard (rev it)
*and after some time it will become loose again (worn out ring/bearings)
*then you operate on it. (rebore/sleeve)
*then tight again (full recon)
*or replace her (new engine)

*if you read this info the wrong way then i'm sorry.but this is the way i was told to build engines.(works fine)ha ha. cheers