Browsing this Thread:
1 Anonymous Users
|
|
B210 20mm stabilizer bar vs. 110 bar |
|
Home away from home  
Joined:
2004/7/22 4:52
From Seattle ,WA.
Group:
Registered Users
|
I have the 20mm bar, went to buy the bushings for it (the ones on the ends - 4 ea. side) & the whole assembly is about 1" taller the the stock 110 setup. I'm not sure but it looks like I'll have a clearance problem w/the bolt either hitting the strut assembly.
Bought - Moog K8989 & Moog K9255 kits
For those of you that have done this swap - what did you use for a bushing kit? The 110 one's are unavailable over here, I thought about using the new 210 bushings on the 110 bolt but the ID is too big or going to a shorter bolt but it doesn't look like the bush will compress that much nor would I want it too.
Anybody have any good solutions?
Thanks a lot.
Posted on: 2010/11/9 15:58
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
