Hi Guys

Reassembled the Starter Motor Cleaned the stator and armature and will be installing a new set of brush set soon,and found viper motor was in good condition i used it sparingly it used to stuck the moving arms always

and reassembled the carburetor with rebuild kit with factory specs jets.

Had to put little putty on minor scratches found on the behind and behind doors together and wet sanded them to the smoothest possible,found that the filler primer was not enough thick to keep it strong enough when sanding and found my gun tip was smaller than paint manufactures specs ,no problem there will be another complete filler coat later on,so had to put a little oil primer on those areas to avoid them get rust by next week end

thanks
regards
sumith

Attach file:

---

  1.jpg (68.59 KB)


  2.jpg (72.47 KB)


  3.jpg (66.14 KB)


  4.jpg (65.88 KB)


  5.jpg (54.65 KB)


  6.jpg (64.63 KB)


  6.jpg (64.63 KB)


  7.jpg (76.67 KB)


  8.jpg (76.63 KB)


  9.jpg (64.77 KB)


  10.jpg (50.49 KB)


  11.jpg (64.54 KB)


  12.jpg (50.49 KB)


  13.jpg (58.58 KB)


  14.jpg (60.02 KB)