Browsing this Thread:
1 Anonymous Users
|
|
Re: RHS sub frames. |
|
Home away from home  
Joined:
2010/1/31 10:26
From Melbourne
Group:
Registered Users
|
Thanks for the reply's fella's.
Datsfullysik - thanks for a little confidence in regards to this possible strengthening attempt. I am asking the question cause if i was an engineer i wouldn't like to see bent up rails with new floor pans on a over powered ute when i went to sign it off lol. So how far did you go with the rhs under the floor?
Wardy - If you say it can be done then i believe you...Do you want to do it lol. Joking mate i think it will be a nice clean look under there so will give it a crack and see how it pans out. Or if i can un stitch the floor pans that are there and straiten the rails while there still in...? Then strengthen them after. Hmmm ideas ideas. I wished i had a welder and some skills with them.
Il be going to my uncles factory to play around with this stuff so i hope it pans out ok
Posted on: 2011/4/3 0:48
|
|
_________________
For a cheap car these datos can get super expensive....!
All the bits for my ute have been acquired, I only need time and a panel beater/painter! Anyone able to help
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
