Browsing this Thread:
1 Anonymous Users
|
|
Re: mig welder |
|
Just can't stay away  
Joined:
2005/12/9 19:24
From Florida, USA
Group:
Registered Users
|
In welding with a wire feed using flux core I have had reasonable results. You end up with a weld that looks like it was done with a stick welder. Chip the flux barrier off and brush with a wire brush and it should look just fine. The advantage of it is if you need to weld outdoors as there is almost no day that is still enough to not blow the gas shield away. Then you get a real mess and porosity. Make sure that you switch the polarity when welding with the flux core wire.
I agree that the Ebay wire feed welders are suspect. As was suggested earlier, save a bit longer and get a Lincoln or a Miller. Hobart makes a nice unit as well. There are others that will work but as was suggested, parts may be a bit of a problem.
Posted on: 2011/4/25 3:29
|
|
_________________
Carbon offset purchases are the Environmentalist equivalent of Television Evangelists being caught with Hookers.
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
