Just after putting in the 5 speed I rebuilt into the car (lifted it up and put on 1 bolt real quick - PITA to do with only myself but I did it!).

I thought It would be a good idea to install the clutch cable and check clutch operation...or lack of.

Seems to be when I brought my gear box I was given a A12 bearing carrier? Yes/no?!

My situation is that I have an A12 enigne/A12 clutch/A12 flywheel/A12 Pressure plate and I want to install a 60 series 5 speed (from a B310 Sunny wagon). What size carrier do I use?

The stock 4 speed bolted onto my A12 used a carrier that was 27mm from the bearing shoulder to the surface the throw out arm sits on (on those 2 tabs) and the one I got when I brought my 5 speed also measured 27mm.

HOWEVER, I beleive this in the long one already (27mm) so I dont know that to do.

I mean I can make one up from a bit of solid Hi tensile steel to whatever dimention I need to fit (I'll measure it) but I was just wondering where did I go wrong If I already have the "long" carrier and it doesnt work? Would I need the A15 flywheel too in that case?