Browsing this Thread:
1 Anonymous Users
|
|
Re: Clutch release bearing carrier |
|
Home away from home  
Joined:
2010/4/27 11:04
Group:
Registered Users
|
That 4.5mm there is a coincidence I think.
I have the 27mm carrier AND I added 5mm on top of it.
Anywho - I fitted it and it worked! Being a new clutch a fair bit of slack had to be pulled out (so that when the clutch wears I have excess cable to increase the slack to get full engagement).
Right now the cable is adjusted so that the clutch fork can be wiggled buy hand about 3 mm at the top - I will readjust this and keep a close eye on it as clutch beds in.
And when the clutch is pressed two thirds of the travel builds up in force (it gets harder and harder) then at the last third of travel it "lets off" kind of like a compound bow being drawn - in other words its how I like it and has a good positive feel.
Cant wait to roadtest the gearbox rebuild/new clutch - but first I need to make the crossmember and install new boots on the tie rods/ball joint and cross rod.
Posted on: 2011/4/28 10:42
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
