Browsing this Thread:
1 Anonymous Users
|
|
Re: L16 into 1200 |
|
|
Guest_
|
yeah im not sure how an a series atuo tail shaft would work, datsandy shortened his too.
only white sedan had success with it i think.
im using a ca18det radiator. works ok.
if ou sit the engine too high, it will hit the bonnet, if too low, then it can be an issue and need sump mods.
pigdog can advise of which engine mounts are best. i think 200b ones sit it up a little higher.
worrd of advice, its going to be a very tight fit to get the engine and box in in one go with just an auto tunnel. we just got it in with a bluebird tunnel (or was it a 180b one? cant remember now 100%).
the under dash set up seems easier, but i lacked the skills and $$ so just used piggys old setup once he went under dash.
Posted on: 2011/5/1 12:42
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
