You'd be amazed at how much dirt I've managed to clean out of this harness, cant believe it could of gotten this much in it! So as I un-molest this wiring loom I keep running across little changes that are a bit confusing, I've completely unwrapped it which is a good thing cuz chasing these issues in the car would be a royal pain.

here's part of the loom, this has 2 fuse holders - previous owner must of had another power need, it was attached to the blue switched lead running down with the trans tunnel leads - it was also pulled out of the but connector in side the loom.. I think I'll replace the original white one with a new one as well







I assume this is a internally regulated alternator....







I also assume this is the correct jumper for the voltage regulator... white/black to white/red




I'm a little confused about this wire, looks like 12 GA. white/red trace located in the coil branch of the loom, I'm guessing this is the alternator feed but as you can see the alt wire is much smaller GA. - is this the charge wire for the battery?




Its a bit confusing but I think I'm almost there is getting it sorted out, if anyone can shed light on the 12GA W/R wire that'd be great.

Thx.
E