Browsing this Thread:
1 Anonymous Users
|
|
Re: shorten boss kit |
|
Home away from home  
Joined:
2010/11/29 10:31
From Adelaide Hills
Group:
Registered Users
|
Did it tonight, made a boss kit. Happy as.
Step 1) cut the spline out of stock boss kit
Step 2) machine it till smooth strong and looks a bit nicer
Step 3) drill out a plate that fits over the spline with aftermarket bolt holes
Step 4) cut out and round off plate
Step 5) on a perfectly flat surface space up your plate so its square with the back of the spline piece and weld it
I now have my imported nardi steering wheel (came in a R32 I imported) sitting about half an inch from the steering column cover. Had to bend the indicator stem a lot but so much more room for my arms. A little too close to my knees now but still good. Down side is the nut that holds the boss on is now closer to me than the wheel so in a bad crash it would hurt. Not recommended for road use, haha
Posted on: 2011/6/4 16:16
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
