Good to see I am not alone with this wee challenge.

Been working on building a 4AGE ITB setup for my A15 motor for my 1200 coupe restore for the last 18 months or so on and off.
Think I have got pretty much all my bits sorted out, just some wiring, fuel lines & fab work on the manifold to sort out.
First Photo shows a mock up of the assembled ITB setup (will be abut 5° steeper inlet angle than shown).
Second photo shows all my bits; 1) 10mm Laser cut inlet manifold (ex Ebay AU), 2) Custom machined inlet tubes (yet to be match ported), 3) Bosch “shorty” injectors, and Custom fabricated injector pocket tubes (ex Ebay USA), 4) 6mm Laser cut ITB mounting plate, I had made locally (yell out if anyone wants the DXF file), 5) blasted & cleaned up 43mm Silver top 4AGE quad bodies, 6) Techno Toy tuning T3 red anodized trumpys (yummy).

Get my car back in a few weeks from the panel beaters all going well, so will trial fit up motor, wire up the Megasquirt, and hook up some juice etc, and do final fab work on the manifold.

http://img121.imageshack.us/img121/3053/dscf2251x.jpg

http://img715.imageshack.us/img715/3492/itbbits.jpg

Attach file:

---

  DSCF2558.JPG (24.41 KB)