some pics when replaced the floors thanks to hermit on ebay still had to trim and bash them with a precision tool to make them fit , but had to make those bits for the inner sill etc, as it was rusted out and i wasnt sure how it was meant to look so just did what i thought. also made some new sills up that run under the floor pans and actually used a plank of timber 50mm wide and shaped with a grinder till the old sills fitted perfectly then screwed a bit of sheet steel to it and bent over with a hammer, i reckon its the best way to make a sill with that nice rolled edge and tappered too like original. i must patent that bit of tooling haha.

Attach file:

---

  IMG_0420.JPG (101.39 KB)


  IMG_0451.JPG (61.23 KB)


  IMG_0460.JPG (59.49 KB)


  IMG_0483.JPG (89.77 KB)


  IMG_0484.JPG (82.64 KB)