Hi guys need some help, just finished doing a ca18det conversion in my 1200 and I can't get it to start.

So far it winds over, fuel pump is working, have 12v and earth at the coilpacks but no signal to trigger them, no injector pulse or constant power to the injectors.

The ecu has power and is bringing up code 13 (coolant temp sensor) which won't stop it from starting and code 11 (crank angle sensor circuit)

I have tried replacing the crank angle sensor with a working unit and have had no luck, it has 2 wires with 5v at them with the ignition switched on.

I am running out of ideas, does anyone have any advice before I start to pin all the wiring out and check continuity.

Thanks