Todays job. Cut Auto tunnel out of old Coupe sticking to the original seam, except near seat rails of course as Auto tunnel actually goes back past the seat rails, and 1/3rd the way into rear floor. Then cleaned off remaining bit of floor pan and firewall by carefully grinding the spot welds down, then flapper disc on grinder. Cleaned off 40ish years of grease and dirt on under side. Now to remove old mounts and linkage guide thingy and then on to other side removing old tar and crap so we have a nice clean slate to fit to ute.

P.S I've changed me mind goin L series in wagon and CA and stumpy in Ute now.

Attach file:

---

  Tunnel 001.jpg (82.73 KB)


  Tunnel 002.jpg (85.26 KB)