Racer, brother i will try your wiring, i did do the valve adjustment before when hot about .35mm, i will re adjust the clearance on cold again, there is no bolt on the carby with wires no wires at all, bro i would buy the points conversion kit with my eyes closed but the cost is too much, in my country you can get 50 to 60 distributors for that price, can you guide me as to which Electronic Ignition Distributor can i replace the stock one with and with minimum alteration if possible, Thanks, i am posting a few pics of the coil,

the volts are not specified on the coil, the resistance is 1.0 ohm
The voltage coming from the battery to the coil is 13.4 14v!!...

Attach file:

---

  IMG0438A.jpg (56.86 KB)


  IMG0439A.jpg (50.25 KB)