hi looking to find something like this pic ture below.
basically need to mod a longer throllte cable for my new intake manifold.
rc provided two cables from his stash- just need to get the right kind of connection on the end - same as stock a series one.

its been sugested to use solder but i think its too soft and will wear through eventually leaving me stranded.

i thought of something similar to this as i found a bolt and a was going to drill a hole through it for the cable. was going to get it brazed onto the end so cable wont move.

any sugestions or ideas that might help? dont really want to pay for a new cable again..... $70 odd.


apparently lawn mowers etc use these kind of things. worth a shot or not reliable enough?

Attach file:

---

  images_nipple20small.jpg (8.42 KB)