in all honesty the flywheel cost me a couple of jokes while i watched my mate a machinst spin it in the lathe haha was pretty fortunate.and if anyone pays for postage i can do any flywheels down to that level of machining fot $50 each and would be happy too, the ute is gettin bodywork/fiberglass work done at the minute,also making a carbonfibre bonnet and hardlid, not going to bolt engine in until all body work is finished and ute is sprayed in the very same blue that the peter jackson ford sierras were that used to run at bathurst, which i must add glenn seton used to drive is parked next to my ute being restored.