Hi guys, I have been doing some research on what exhaust system I am going to run with and I just wanted to run it past you to make sure I am thinking along the right lines.
The exhaust end of my extractor is 2 inch.
So would I be looking at a 2 inch pipe going through to a backbox and then a 2 inch tail pipe?
Or should I be looking at a 2.5 inch set up, I take it I have to run a backbox?
Basically looking for the best setup to get the most of of the extractor, as far as performance & sound is concerned but also keeping it legal as it has to go through a blue slip.
What would you guys suggest / Or what have you used?
Thanks
Andy