Browsing this Thread:
1 Anonymous Users
|
|
CA18DET motor rebuild, what's involved DIY |
|
Home away from home  
Joined:
2010/1/2 8:56
From Sydney
Group:
Registered Users
|
Hey lads, I'm toying up buying a 2nd motor ( project motor ) to swap into my 1200 eventually, I know what's generally involved but I'm confused when clearances are talked about, I want to run 14+ psi so I know I'm gonna need forgies,rods,bearings, I've heard of a few brands and not scared to spend
Is it worth just getting a shop to put it he block together with rods, bearings n all?
Also if I bored out the block can I go ca20det and which pistons can I use?
Cheers boys
Posted on: 2013/1/6 12:20
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
