Browsing this Thread:
1 Anonymous Users
|
|
Re: MSII + EDIS Qs |
|
Moderator  
Joined:
2001/5/3 7:04
From 48 North
Group:
Registered Users
Contentmaster
Usermaster
|
I run EDIS, and found poor signal to be usually one of two potential causes:
* cable. the signal cable must be twisted pair, very small wires are OK. And the ends of the cable must not be untwisted any more than needed to connect. Cable must be shielded, and the shielding must not be removed too much at the ends, again just enough to make the connection. I used an antique electric guitar cable and get a good signal. Ethernet cable won't work as it is not Shielded.
* sensor too far from the trigger wheel. Sensor-to-tooth clearance is 0.040 inch or less
Posted on: 2013/9/7 7:12
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
