Browsing this Thread:
1 Anonymous Users
|
|
Attaching rear quarter panels (ute) |
|
Just can't stay away  
Joined:
2013/1/15 2:47
From Gold Coast Queensland, Australia
Group:
Registered Users
|
Its the panel from door to tail light corner panel.
I want to know if anyone has attempted this themselves and has any helpful hints/feedback.
So far this is all the info I have;
I need to drill the spot welds off the upper outer side. What about inside the door frame and the bottom of the panel?
Remove the panel with a chisel (and /or grinder) between the inner and outer.
Clamp new panel in position and weld. Mig welder? What is the smallest amp mig up for the job?
Any extra info or comments very welcome. Cheers
Posted on: 2014/1/15 0:03
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
