This is a brain storm thread on making a cheap external oil pump
for an engine that Im planning in the future that will need it.

http://datsun1200.com/modules/mediawi ... le=High_Capacity_Oil_Pump

Im thinking of finding out how to use the L series bits as done on the link up above
but also just wanting to use the larger L series shaft to drive the pulley.

Im thinking of using AN fitting on a thick bracket that will also house a seal to stop any leaks from the shaft onto the pulley. It will be relatively cheap once sorted.

Here is the idea so far

Attach file:

---

  datsun pumpmodded2.jpg (63.40 KB)


  datsunpumpMODDED.jpg (92.76 KB)