Browsing this Thread:
1 Anonymous Users
|
|
Re: Datsun 1200 ute |
|
Home away from home  
Joined:
2002/9/10 7:23
From Melbourne, Australia
Group:
Registered Users
|
Yeah when l took the clock out of my ute l found that it just had three screws holding it in. There is one at 1, 4 and 8. There is also a bracket attached at 5 that may have a little bolt through it but l cant remember.
The screws run from behind the dash into the dash, so use about a 100mm shaft phillips head (screws are close to the clock housing), and go under the dash. There's plenty of room.
Then all you have to do is unplug the wire.
There is no need to remove the dash or anything else at all
Cheers
Posted on: 2002/10/7 23:40
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
