Browsing this Thread:
1 Anonymous Users
|
|
Which spring/insert for Coilovers? |
|
Home away from home  
Joined:
2014/2/18 9:33
From Melbourne
Group:
Registered Users
|
I'm back from overseas and I have plans for coilovers for the front.
So far I've sourced a set of complete 280zx struts and all the bits needed to make the 2" strut swap. I plan on using the Datsport coilover sleeve so I can run 65mm springs, use a dust boot and weld the sleeve on with the potential to run their camber tops in the future.
What I'm wondering is which spring rate and length should I be using and with which insert? I plan on running 95% street, 5% track and would lean to more of a firm ride. Currently I'm running an A12, with plans to move to an A14 in the future.
I'd also like to know if people have removed a section from the 280zx strut to shorten it before welding on the sleeve, I'd like to get the car as low as possible.
Cheers
Posted on: 2014/7/30 11:59
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
