These are 36mm Mikuni RS flat slides with pumpers on a A15 with forged pistons, big valves , big ports ( bigger than a GX! ) Wade 140 cam, H rods , Crank - rods - pistons - A12 flywheel and 190mm clutch all balanced.
It was a job and half to make the manifold and all the other bits, but it came up a treat.
It pulls like a train and haven't even had it dynoed yet. You might have gathered i'm a little chuffed - so sorry about that.
This might bring on some hate but Im never going to bother with Webbers/Dellortos/Solexes again ( jets, emulsion tubes ,air corrrectors - all too complicated and expensive )

Attach file:

---

  photo-3.JPG (46.42 KB)