Checked all listings for the H-beams and even enquired with the manufacturer. Weirdly they don't offer the 19.7mm pin. They also say you must have a minimum bore size of 76mm which is weird. Apparently their rods were modeled off their engines 75mm size bore even though stock bore is 73mm. This leads me to think they modeled it off one of their A12A's with the 75mm bore but somewhere along the line decided to make the pin 17.45. Strange.

I was only going to go to a 19mm pin if going forged Pistons but have decided to stick with the original plan for the time being and spend the money elsewhere. Might be an upgrade later down the track. Cast should be good for the power I'm trying to achieve.

A set of A12A rods would be nice to have even if they were to sit on the shelf for the time being.