Browsing this Thread:
1 Anonymous Users
|
|
Re: Reverse light switch thread/size? |
|
Home away from home  
Joined:
2007/9/4 15:03
From Fremantle, West Australia
Group:
Registered Users
|
I THINK it is M14 1.5 not easy to find in a pipe socket plug (flush fit)
if you are wanting to plug the rev switch hole, you can put a grinder through the switch near the wires, remove the rod and spring, secure the hex bit in a vice, drill & tap for M8 1.25. Then carefully cut the threaded section from the hex section. Grab am M8 1.25 bolt, cut a screwdriver slot in one end, trim to length, screw and loctite into the newly tapped bit. You end up with a flush fitting plug with a handy slot in the centre.
The rev switch thread is parallel (not tapered) so some thread sealant would be wise to make sure the plug does not fall out or worse, fall into the gearbox.
Posted on: 2015/4/7 6:44
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
