Ok, we are away Ron

So, my advice with the reproduction panels.
I'll just say, I'm fairly handy with metal, However I'm not a professional panel beater or sheet metal worker.


Before removing the rear quarters
I started with fitting up the new front doors and new hinges.
Line them up to suit existing rear quarter panel gaps. I even fitted the locks to see how the looked closed.

Then, try fitting the new front guards. Matching them to the front of door and plenum/ water box
(Bolt holes need some enlargement with a small round file here)

I then fitted up my new bonnet to see how I was looking.
Looking not too bad, I then cut/grind/drill off spot welds and removed the front lower apron.

I will try add a photo at this point.

I can't seem to add a photo just yet, sorry