Got some parts, thanks to Brisbane fuel injection for the intake, serious if anyone needs any good upgrades then check the shop out, good prices too. But doesn't the intake tb and fuel rail look hot or what. Also mcdonald bros racing sent out the triangualted 4 link parts but had to get different brackets so have started to piece it together. In the photo I just made some 3mm plates up for the chassis and had to modify the tail shaft loop as it was too low do cut a section out and tig it back together to make it sit higher on car. There isn't much room to run these bars but will get some more done later. Going to get some more plazmaman clamps and adapter for this bosch tb and do cold side piping then it's whatever next

Attach file:

---

  20200501_152749_compress29.jpg (174.44 KB)


  20200501_152802_compress23.jpg (175.08 KB)


  20200501_152853_compress55.jpg (167.44 KB)