Yup .. its so much fast now .. cant wait to get some new footage of it. the whole botom half i built up! Bored 40 over to increase from 89mm bore to 90mm with oversized stock pistons, new rings. I also raised compression a bit by decking the head. I also put valve release in the pistons for the big cam im running. knifedge crank, lightend flywheel, underdrive pullies, ported and poslished my head and portmatched manifold and also a must SOLID LIFTERS "Have had since begining because i was dropping valves when hydrolic lifters failed at high rpm." soon will try my 50mm in place of my 45mm! u will all soon see the wrath! ALSO im currently in proccess of building a 80 over motor with 91 mm bore / pistons. nissan dont make these so im going with a different piston i found that will work .. going to have to mod the head gasket also. Had a stroker crank made for it .. so it will go from 2.4 stock to 2.7 stroked! :)