Browsing this Thread:
1 Anonymous Users
|
|
ignition timing 120y |
|
Just can't stay away  
Joined:
2010/4/15 9:45
Group:
Registered Users
|
have pulled my distributor out and would like to know
the proper way about re-installing it
should the points open at 7 degrees defore top dead centre clockwise or anticlockwise
can someone give me a run down of how this is to be done without a timing light, say with a circuit test light
from what i know i put the distributor in with the rotor facing #1 spark plug wire at 0 deg tdc
and the points open at 10btdc with the rotor going ccw
although this gives me a nice idle, i get a bit of a backfire from the engine at high rpms without load
i'm also getting some white smoke in the exhaust but this might be because of condensation
Posted on: 2010/6/12 11:43
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
