Browsing this Thread:
1 Anonymous Users
|
|
Brake Warning light |
|
Home away from home  
Joined:
2010/4/27 11:04
Group:
Registered Users
|
Hi,
In my B310 sunny I've bled the brakes and they work fine plus the 2 master cylinder resivors are topped up and the brake warning light is always on!?
My car only has the float switches in the resivour caps (no proportioning valve switch). So I've unpluged the float switch caps from the wiring and the light still is on. Then I put a jumper between the 2 bullet connectors and the brake light is still on?
How does this light work? Do the float switches complete the circuit and allow power to the light? Or does it short to ground when there is low fluid? any wiring diagrams about?
The brakes work fine but it just doesnt look right when the brake light is on.
Posted on: 2011/5/27 3:44
|
|
|
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
Transfer
